FXCW/C HORN RELOCATION KIT
J045622007-10-17
GENERAL
Kit Number
69015-08
Models
This kit is needed to complete the installation of an oil cooler on specific FXCW (Softail® Rocker™) and FXCWC (Softail Rocker C) model motorcycles.
Please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only) for model fitment information and the correct Oil Cooler Kit part number.
Tools and Supplies Required
Loctite® 243 (Blue) Threadlocker and Sealant (H-D Part Number 99642-97) is required for the proper installation of this kit.
Kit Contents
This kit consists of a new horn bracket and these instructions. There are no service parts available.
INSTALLATION
WARNINGTo prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)
| 1. | Refer to the Owner's Manual and follow the instructions given to remove the main fuse. | |
| 2. | See Figure 1. Remove the hex head screw (2) and lockwasher (3) to detach the original equipment (O.E.) horn bracket (1) from the vehicle. | |
| 3. | Disconnect the wires from the posts on the back side of the horn. | |
| 4. | Remove the locknut (5) to detach the horn and cover assembly (4) from the bracket. NOTE Position the horn terminals between the two ears on the new bracket. | |
| 5. | With the horn terminals between the ears, insert the horn mounting stud through the small hole in the new bracket (6). Apply a few drops of Loctite Blue to the stud threads, then fasten the horn to the bracket with the locknut (5) removed earlier. Tighten securely. | |
| 6. | Connect the wires to the posts on the back side of the horn. | |
| 7. | Attach the horn bracket to the vehicle using the lockwasher (3) and screw (2) removed earlier. Tighten to 17.6–20.4 N·m (13–15 ft-lbs). | |
| 8. | Verify that the Ignition/Light Key Switch is turned to the OFF position. Refer to the Owner's Manual and follow the instructions given to re-install the main fuse. | |
| 9. | Test the horn for proper operation. |
| 1 | Original equipment horn bracket |
| 2 | Hex head screw |
| 3 | Lockwasher |
| 4 | Horn and horn cover assembly |
| 5 | Locknut |
| 6 | New horn bracket |
Figure 1. Horn Installation