TRI-BAR RUN AND BRAKE LIGHT
J049602009-06-05
GENERAL
Kit Number
67774-10
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
There are no Service Parts available with this kit.
Figure 1. Tri-Bar Run and Brake Light
1Shield
2TORX screws (2)
3Rear fascia lamp
Figure 2. Rear Fascia Lamp
REMOVAL
  1. See Figure 2. Remove shield (1), and disconnect rear lights harness and tail light jumper harness from fascia lamp (3).
  2. Remove two screws (2) and fascia lamp.
INSTALLATION
1.
Install new fascia run/brake light with the two T-20 TORX® screws and alternately tighten to 2–2.5 N·m (18–22 in-lbs).
2.
Connect rear lights harness and tail lamp jumper harness to fascia lamp.
3.
Install shield.