CLUTCH MASTER CYLINDER COVER KIT
J063402016-08-22
GENERAL
Kit Number
37000278
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
Turn front wheel toward the right fork stop and level off master cylinder.
WARNING
Contact with DOT 4 brake fluid can have serious health effects. Failure to wear proper skin and eye protection could result in death or serious injury.
  • If inhaled: Keep calm, remove to fresh air, seek medical attention.
  • If on skin: Remove contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. If irritation develops, seek medical attention.
  • If in eyes: Wash affected eyes for at least 15 minutes under running water with eye lids held open. If irritation develops, seek medical attention.
  • If swallowed: Rinse mouth and then drink plenty of water. Do not induce vomiting. Immediate medical attention required.
  • See Safety Data Sheet (SDS) for more details available at sds.harley-davidson.com
(00240d)
NOTICE
DOT 4 brake fluid will damage painted and body panel surfaces it comes in contact with. Always use caution and protect surfaces from spills whenever brake work is performed. Failure to comply can result in cosmetic damage. (00239c)
Cover nearby motorcycle surfaces with a polyethylene protective sheet to help protect against damage to finish caused by spillage of DOT 4 brake fluid.
If DOT 4 brake fluid contacts painted surfaces, IMMEDIATELY flush area with clear water.
1. Clean the front clutch master cylinder cover and the surrounding area. Remove and discard the original cover, gasket and screws.
NOTE
The clutch system on this vehicle uses DOT 4 BRAKE FLUID. Do not mix grades of brake fluid as they are not compatible. Mixing different types of fluid may adversely effect the clutch and lead to clutch failure which could result in death or serious injury.
WARNING
Contact with DOT 4 brake fluid can have serious health effects. Failure to wear proper skin and eye protection could result in death or serious injury.
  • If inhaled: Keep calm, remove to fresh air, seek medical attention.
  • If on skin: Remove contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. If irritation develops, seek medical attention.
  • If in eyes: Wash affected eyes for at least 15 minutes under running water with eye lids held open. If irritation develops, seek medical attention.
  • If swallowed: Rinse mouth and then drink plenty of water. Do not induce vomiting. Immediate medical attention required.
  • See Safety Data Sheet (SDS) for more details available at sds.harley-davidson.com
(00240d)
2. Fill reservoir with DOT 4 brake fluid. Do not reuse old brake fluid. Use only DOT 4 fluid from a sealed container.
WARNING
Be sure the master cylinder relief port is not plugged. A plugged relief port can cause brake drag or lockup and loss of vehicle control, which could result in death or serious injury. (00317a)
3. Verify proper operation of the master cylinder relief port by actuating the clutch lever. A slight spurt of fluid will break the fluid surface in the reservoir if internal components are working properly.
NOTE
Before installing the master cylinder cover, verify that the cover gasket bellows is not expanded. If bellows is expanded, brake fluid is ejected from the reservoir during cover installation, which could damage the vehicle finish.
4. See Figure 1. One end of the master cylinder cover is taller than the other. Install the cover (with gasket compressed) on the master cylinder reservoir. Position the taller end above the clutch line fitting. Fasten the cover and gasket to the reservoir with the two captive screws. Tighten the screws to 0.8–1.2 N·m (7–11 in-lbs).
SERVICE PARTS
Figure 1. Service Parts, Master Cylinder Cover Kit
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Decal, DOT 4 brake fluid
98-16711
2
Screw (2)
42858-06A
3
Cover, front clutch master cylinder
Not sold separately
4
Gasket, master cylinder cover
36700147