THERMOMETER/ CLOCK, HAND LEVER BRACKET CLAMP MOUNT
-J027442018-07-03
GENERAL
Kit Numbers
75041-03, 75042-03, 75102-04, 75104-04, 75108-06, 75115-06, 70900307, 70900308
Models
These kits fit all models. They are not compatible with Auxiliary Switch Housings 70213-02, 70248-02, 70255-02 or 70256-02.
Kit Contents
Table 1. Kit Contents
Description (Quantity)
Part Number
Clock or Thermometer
Not Sold Separately
Bracket
69144-03
Set screw, socket head
4283M
INSTALLATION
NOTE
The figures show the gauge mounted to the clutch (left-hand) lever clamp. The gauge can be mounted on either the clutch or brake lever side, using the upper or lower clamp mounting screw per customer preference.
1Gauge
2Bracket (bent backward)
3Socket head set screw from this kit
4Original equipment screw
5Original equipment washer (front of bracket)
Figure 1. Gauge Bracket Mounted to Upper Screw (Left-Hand Shown)
1. See Figure 1 and Figure 2. Using a T27 TORX drive head, remove the desired screw (upper or lower) with flat washer securing the handlebar clamp to the hand lever bracket.
NOTE
When mounting the gauge bracket to the lower clamp mounting screw, install the original flat washer behind the bracket.
2. Install the handlebar clamp screw with flat washer through the larger hole in the gauge bracket. Tighten.
Torque: 6.8–9 N·m (60–80 in-lbs) clamp screw
3. Rotate the gauge to the desired angle, then tighten the gauge attaching screw securely.
4. Slowly rotate handlebar from stop to stop to verify there is no contact with the fuel tank.
SETTING THE TIME ON THE CLOCK
NOTE
The clock is shipped with the stem pulled out, which stops clock operation.
If the stem has been pushed in, pull out the stem carefully, and turn it until the hands indicate the correct time. Carefully push the stem back in to start the clock.
REPLACING THE CLOCK BATTERY
The clock battery (Type SR626SW) is a common type, available wherever watch batteries are sold. It is recommended that the battery be replaced at a watch repair facility, as the screw back cover requires a special tool for removal and replacement.
The clock is waterproof, and requires special attention when re-assembled.
1Gauge
2Bracket (bent forward)
3Socket head set screw from this kit
4Original equipment screw
5Original equipment washer (behind bracket)
Figure 2. Gauge Bracket Mounted to Lower Screw (Left-Hand Shown)