FAT BOB EXHAUST SHIELDS
J066482018-08-20
GENERAL
Kit Number
65400472
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Separate purchase of ANTI-SEIZE LUBRICANT (98960-97) for proper installation of this kit.
Kit Contents
See Figure 1 and Table 1.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
NOTE
A service manual for the year and model motorcycle is available from a Harley-Davidson dealer.
INSTALLATION
Remove Original Equipment (OE) Exhaust Shields
  1. See Figure 1 Remove the six screws and the collector shield (A).
  2. Remove the four pipe shield clamps (B) and the exhaust pipe shields (1, 2).
  3. NOTE
    Note the position of the OE clamp screws securing the exhaust shields to the exhaust pipes.
  4. Remove the clamps from the exhaust shields and save for installation.
Install Exhaust Shields
1.
See Figure 1. Install the OE clamps to the new exhaust shields. Position the clamp screws as previously noted.
2.
Install and loosely position the new pipe shields.
3.
Apply anti-seize lubricant to screws.
4.
Install collector shield.
5.
Install screws.
NOTICE
Wipe all fingerprints off of exhaust system components after installation and before starting engine. Oil from hands can leave permanent marks on exhaust system finish. (00346a)
6.
Secure the screws. Tighten.
Torque: 8.8–10.8 N·m (78–96 in-lbs)
7.
Position and secure the pipe shield clamps. Tighten.
Torque: 2.3–4.5 N·m (20–40 in-lbs)
SERVICE PARTS
Figure 1. Service Parts: Fat Bob Model Exhaust Shields
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Exhaust shield, rear
Not Sold Separately
2
Exhaust shield, front
Not Sold Separately
Items mentioned in text, but not included in kit
A
Exhaust collector shield
Not Sold Separately
B
Exhaust shield clamps (4)
9955
Anti-seize lubricant (not shown)
98960-97