SPORT GLIDE EXHAUST SHIELDS
J066472018-08-20
GENERAL
Kit Number
65400480
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
NOTE
A service manual for the year and model motorcycle is available from a Harley-Davidson dealer.
INSTALLATION
Remove Original Equipment (OE) Exhaust Shields
  1. See Figure 1. Note the position of the OE clamp screws (1) securing the exhaust shield (2) to the exhaust pipe. Remove the exhaust shield.
Install Exhaust Shields
1.
Remove the clamps from the exhaust shield and save for installations.
2.
Install the OE clamps to the new exhaust shield making sure they are positioned as shown in Figure 1.
3.
Loosely position and install the exhaust shield.
NOTICE
Wipe all fingerprints off of exhaust system components after installation and before starting engine. Oil from hands can leave permanent marks on exhaust system finish. (00346a)
4.
Secure the clamp screws. Tighten.
Torque: 2.3–4.5 N·m (20–40 in-lbs)
1Exhaust shield clamp
2Exhaust shield
Figure 1. Exhaust Shield Clamp and Exhaust Shield