SOFTAIL SWINGARM BAG
J066342018-08-20
GENERAL
Kit Numbers
90201768
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
WARNING
Do not exceed swingarm bag weight capacity. Too much weight in swingarm bag can cause loss of control, which could result in death or serious injury. (00618c)
NOTE
Maximum capacity 1.81 kg (4 lb).
This kit is for 2000-2017 Softail Models
Kit Contents
INSTALLATION
1.
See Figure 1. Attach three hook-and-loops to back of bag.
NOTE
Attaching bottom hook-and-loop first will aid in the ease of setting the correct height adjustment for top of bag placement.
To avoid paint scuffing, apply protective tape to swingarm before attaching bag to vehicle.
Figure 1. Attach Hook-and-Loop (Typical)
2.
See Figure 2. Cut anti-abrasion tape into three, 3 in pieces, and attach to swingarm.
3.
See Figure 3. Secure bottom hook-and-loop (2) on bag (1) over anti-abrasion tape (3) to bottom swingarm location (3) per Figure 2. Tighten until top mounting points on bag line up with the upper swingarm tube, leaving slack in the hook-and-loop.
4.
Adjust and tighten hook-and-loop on upper mounts as much as possible.
Figure 2. Anti-abrasion Tape and Hook-and-Loop Placement
5.
Trim excess hook-and-loop.
6.
See Figure 3. Secure remaining two hook-and-loops over anti-abrasion tape to top of swingarm.
7.
Tighten hook-and-loops as much as possible.
8.
Trim excess hook-and-loop.
9.
Verify bag is secure and mounted vertically as high as possible.
NOTE
Loose mounting may cause bag to scrape.
CARE INSTRUCTIONS
NOTICE
Do not use bleach or detergents containing bleach on saddlebags, seats, tank panels or painted surfaces. Doing so can result in equipment damage. (00229a)
Leather, vinyl and other synthetic surfaces must be periodically cleaned and treated to maintain its appearance and extend its life. Clean and treat these surfaces once a season or more frequently under adverse conditions.
These surfaces are not designed for long-term exposure to inclement weather. Protect these surfaces with an HARLEY-DAVIDSON SEAT RAIN COVER or MOTORCYCLE STORAGE COVER (sold separately).
  1. Vacuum or blow dust off surface.
  2. Thoroughly clean outer surfaces with soap and water.
  3. Allow the material to dry naturally and completely at room temperature before applying other products to the material. Do not use artificial means to dry the material quickly.
SERVICE PARTS
Figure 3. Service Parts: Softail Swingarm Bag Kit
Table 1. Service Parts: Softail Swingarm Bag Kit
Item
Description (Quantity)
Part Number
1
Bag, Swingarm
90201768
2
Hook-and-Loop Supports (3)
90201895
3
Anti-abrasion Tape, 9 in
90201957