FXDR PASSENGER FOOTPEG ADAPTOR KIT
J065722018-08-21
GENERAL
Kit Number
505001128
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Proper installation of passenger foot pegs requires the purchase of passenger foot peg supports and foot pegs.
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
Right Side
1.
Remove and discard the black plastic hole plug in the frame, just above the swingarm pivot nut.
2.
Obtain the right-side passenger support bracket (3) and one mount screw (2) from the kit. Install the bracket to the frame, ensuring the contours of the back side of the bracket follow the contour of the frame. Tighten the screw.
Torque: 61–68 N·m (45–50 ft-lbs)
3.
Install the selected foot peg support and foot peg kits. Refer to the instruction sheets in those kits for proper installation.
NOTE
Foot pegs must be installed in the bracket with the rounded side of the mounting end inboard. When foot pegs are properly installed, foot pegs will fold upward and toward the rear of the motorcycle.
WARNING
Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a)
Left Side
1.
Remove and discard the black plastic hole plug in the frame, just above the swingarm pivot nut.
2.
Obtain the left-side passenger support bracket (4) and one screw (2) from the kit. Install the bracket over the rear brake line clamp. Tighten the screw.
Torque: 61–68 N·m (45–50 ft-lbs)
3.
Install the selected foot peg support and foot peg kits. Refer to the instruction sheets in those kits for proper installation.
SERVICE PARTS
Figure 1. Service Parts: Passenger Footpeg Adaptor Kit
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Passenger footpeg kit, black
50500769
2
Screw (2)
4687
3
Passenger footpeg support bracket, right
50501129
4
Passenger footpeg support bracket, left
50501130