Trunk Mount Flag Kits
J011432013-11-01
GENERAL
Kit Numbers
94612-98, 94617-98, 94618-98, 94626-98
NOTE
Flags are not intended for highway use. The construction of these flags will not hold up to the wind speeds seen at highway speeds. These flags are designed for parade use only.
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
Table 1. Kit Contents
Item
Description
Part Number
1
Wear pads (2)
Not sold separately
2
Flag mast
Not sold separately
3
Flag
Not sold separately
4
Rubber pads
Not sold separately
INSTALLATION
NOTE
Water may enter Tour-Paks/saddlebags with flag mast installed during inclement weather.
NOTE
Attaching a flag mast to a Tour-Pak or saddlebag without wear pads in place may result in damage to the Tour-Pak or saddlebag exterior. Periodically check to verify the flag mast remains in contact with wear pads.
  1. See Figure 1. Remove adhesive backing from wear pad and place on area where mast base will hit the painted portion of the Tour-Pak and/or saddlebag. Attach flag mast to Tour-Pak or saddlebag as shown.
  2. See Figure 2. Cut the self adhesive rubber pad in half. Remove the backing from the rubber pads and place on the inside of the Tour-Pak or saddlebags on each side of the flag mast as shown.
Figure 1. Flag Mast Installed on Tour-Pak
Figure 2. Rubber Pads Installed on Interior of Tour-Pak