MASTER CYLINDER COVER KIT
J035322005-08-04
GENERAL
Kit Numbers
42114-06 and 42119-06
Models
These kits fit 2006 and later VRSCR model motorcycles.
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
NOTICE
Do not allow dirt or debris to enter the master cylinder reservoir. Dirt or debris in the reservoir can cause improper operation and equipment damage. (00205c)
1.
Starting with either the clutch or front brake, clean master cylinder cover.
2.
Remove two screws holding cover in place.
3.
Replace the original cover and gasket with the new cover, and gasket.
NOTE
The cover is labeled for D.O.T. 4 silicone brake fluid. Install this cover on reservoirs filled only with D.O.T. 4 silicone brake fluid. Do not mix grades of brake fluid, as they are not compatible and could cause equipment damage.
4.
Install the polished stainless steel cover screws (1) and tighten screws to 0.7–0.9 N·m (6–8 in-lbs).
5.
Repeat procedure for the other master cylinder.
SERVICE PARTS
Figure 1. Service Parts for Master Cylinder Cover Kits
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
Item
Description (Quantity)
Part Number
1
Screw, brake (2)
42882-06
5
Screws, clutch (2)
42882-06
2
Cover, master cylinder, brake
Not Sold Separately
6
Cover, master cylinder, clutch
Not Sold Separately
3
Gasket, master cylinder, brake
42857-06
7
Gasket, master cylinder, clutch
46322-06
4
Decal, master cylinder, brake
42856-06
8
Decal, master cylinder, clutch
42875-06