RADIO FACEPLATE TRIM
J038282006-10-12
GENERAL
Kit Number
77142-06
77143-07
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
Table 1. Kit Contents
Description (Quantity)
Part Number
Radio faceplate trim
Not Sold Separately
INSTALLATION
NOTE
Mounting surface of radio faceplate trim must be above 60°F (16°C), or the trim may not stay attached.
1.
Using a 50:50 isopropyl alcohol/water solution, thoroughly clean the surface where the radio faceplate trim will be installed.
NOTICE
Do not clean with denatured alcohol, mineral spirits, or other solvent products, or component damage may occur. (00411c)
2.
Allow the surface to dry completely before continuing to install kit.
3.
Test the fit of the radio faceplate trim prior to removing adhesive backing.
4.
Remove the adhesive backing from the back of the radio faceplate trim.
5.
Open the auxiliary jack cap and feed it through the radio faceplate trim.
6.
See Figure 1. Position the radio faceplate trim and press firmly into place.
7.
Let the adhesive cure for at least 24 hours at no less than 60°F (16°C).
Figure 1. Radio Faceplate Trim