QUICK RELEASE DETACHABLE WIND SPLITTER WINDSHIELD KIT
J063642018-08-20
GENERAL
Kit Number
57400323, 57400326, 57400327, 57400331, 57400333, 57400334, 57400336, 57400337, 57400361
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
Kits 57400323, 57400334: See Figure 3 and Refer to Table 1.
Kits 57400326, 57400327, 57400331, 57400333, 57400336, 57400337: See Figure 4 and Refer to Table 2.
INSTALLATION
Install the Windshield - All Models
1.
See Figure 1. Remove the windshield sub-assembly from the packaging and place face down on a clean, soft surface with the mount brackets facing up.
2.
See Figure 3 and Refer to Table 1. or see Figure 4 and Refer to Table 2. Remove both the clamp and hardware kits from the packaging, and separate similar parts in preparation for assembly.
3.
See Figure 2. Assemble the clamp assemblies and hardware stacks.
WARNING
The cupped side of the Belleville (cone) washers must face each other and sandwich the windshield mount brackets at each mount point. Failure to orient washers correctly can reduce windshield's ability to break away in a collision, which could result in death or serious injury. (00422b)
4.
One clamp at a time, with the clamp facing upward and inboard of the windshield bracket (2), tighten the shoulder bolts (1) only enough to hold the clamp orientation to the windshield during mounting of the windshield to the motorcycle. The bolts will be fully tightened later.
NOTE
Keep front wheel straight to prevent brackets from scratching fuel tank.
5.
Make sure all four clamps are in the open position, then bring the windshield (with the clamp side away from you) to the front of the motorcycle.
NOTE
The polycarbonate windshield is fairly flexible and can be bent to spread the clamps away from the headlamp to ease installation to the motorcycle. Take care not to scratch the headlamp housing with the clamps while positioning the windshield to the fork sliders.
1Windshield mounting brackets
Figure 1. Windshield Mounting Brackets
1Shoulder bolt
2Windshield mounting brackets
3Cup washer spacer
4Belleville washers (cupped sides facing each other)
5Windshield mounting clamp
Figure 2. Windshield Mounting Clamp
6.
Straddle the front fender. Center the windshield around the headlamp and seat the clamps onto the fork sliders.
7.
Starting at the bottom (either side) and with the shoulder bolts just a little more than finger tight, close each clamp, taking note that the clamps self-align to the fork sliders and to each other.
WARNING
Improper installation of accessories or loading of cargo can affect motorcycle stability and handling, which could result in death or serious injury. (00455b)
WARNING
Failure to provide adequate clearance between stationary and moving parts can cause loss of control, which could result in death or serious injury. (00378a)
NOTICE
Do not exceed recommended torque when installing mounting screws. Damage to windshield can result. (00385a)
8.
With the windshield clamps now clamped to the fork sliders, make sure that the shoulder portion of the shoulder bolts are fully seated in each windshield bracket location. Tighten each shoulder bolt.
Torque: 6.7 N·m (60 in-lbs) Shoulder bolt
9.
For kit 57400361, remove windshield from vehicle to tighten shoulder bolts on the two upper clamps.
10.
Turn the handlebars fully to the left and right fork stops to confirm that the throttle cables move freely.
Removing the Windshield - All Models
  1. To remove the windshield, open the four clamps in any sequence. Take care to not scratch the headlamp housing or fuel tank as noted during installation.
  2. When storing the windshield, place in a location where the windshield clamps will receive the greatest protection. Keep from locations where the windshield may be impacted, dropped or scratched. Do not stack anything on top of the assembly.
  3. Prior to re-installation after any storage period, inspect the clamps and hardware for fastener preload and cleanliness. Each clamp should have a pair of rubber gaskets in the clamp saddle that mates to the fork slider, and should allow the clamp to open and closed freely.
Care and Cleaning
NOTICE
Polycarbonate windscreens/windshields require proper attention and care to maintain. Failure to maintain polycarbonate properly can result in damage to the windscreen/windshield. (00483d)
  • Do not use benzene, paint thinner, gasoline or any other type of harsh cleaner on the windscreen/windshield. Doing so will damage the surface.
  • Do not clean polycarbonate in hot sun or high temperature.
  • Powdered, abrasive or alkaline cleanser will damage the windscreen/windshield.
  • Sunlight reflections off of the inside curvature of a windscreen/windshield can, at certain times of the day, cause extreme heat build-up on motorcycle instruments. Exercise care in parking. Park facing the sun, place an opaque object over the instruments, or adjust the windscreen/windshield to avoid reflections.
  • Do not use benzene, paint thinner, gasoline or any other cleaning agents on the rubber bushings. Doing so will damage the bushing surfaces.
NOTE
Covering the windshield with a clean, wet cloth for about 15 minutes before washing will make dried bug removal easier.
Harley-Davidson Windshield Water Repellent Treatment Part Number 99841-01 is approved for use on Harley-Davidson polycarbonate windshields.
SERVICE PARTS
Figure 3. Service Parts: Super Sport (57400323, 57400334) Quick Release Detachable Windshield Kits
Table 1. Super Sport (57400323, 57400334, 57400361) Quick Release Detachable Windshield Kits
Kit
Item
Description (Quantity)
Part Number
57400323
1
19 In Lt Smoke Wind Splitter Windshield
57400344
2
Grommet (6)
12100057
3
Mount, Wind Deflector (6)
57400244
4
Screw, Flat Head, Hex Socket (6)
10200276
5
RH Windshield Mounting Bracket
57304-06
6
Tool Less Release Windshield Mounting Hardware (4)
58790-04
7
49mm Quick Release Windshield Mounting Clamp Assembly (4)
57192-05A
8
LH Windshield Mounting Bracket
57305-06
9
Acorn Nut (6)
10400018
57400334
1
19 In Lt Smoke Wind Splitter Windshield
57400344
2
Grommet (6)
12100057
3
Mount, Wind Deflector (6)
57400244
4
Screw, Flat Head, Hex Socket (6)
10200276
5
RH Windshield Mounting Bracket
57300119
6
Tool Less Release Windshield Mounting Hardware (4)
58790-04
7
49mm Quick Release Windshield Mounting Clamp Assembly (4)
57192-05A
8
LH Windshield Mounting Bracket
57300118
9
Acorn Nut (6)
10400018
57400361
1
14 In Lt Smoke Windshield
57400394
2
Grommet (4)
11564
3
Mount, Wind Deflector (4)
57400178
4
Screw, Hex Sckt (4)
10200218
5
RH Windshield Mounting Brack
57300194
6
Tool Less Release Windshield Mounting Hardware (4)
58790-04
7
55mm Quick Release Windshield Mounting Clamp Assembly (4)
57300196
8
LH Windshield Mounting Bracket
5730195
9
Acorn Nut (4)
10400051
Figure 4. Service Parts: Windshield Kits 57400326, 57400327, 57400331, 57400333, 57400336, 57400337
Table 2. Windshield Kits 57400326, 57400327, 57400331, 57400333, 57400336, 57400337
Kit
Item
Description (Quantity)
Part Number
57400326
1
Pan Head Machine Screws (7)
2921A
2
Pan Head Machine Screws (2)
2452
3
N/A
N/A
4
Vertical Adhesive Tape (2)
11100168
5
RH Windshield Vertical Brace
57300103
6
LH Windshield Vertical Brace
57300104
7
RH Windshield Mount Bracket
57300137
8
LH Windshield Mount Bracket
57300138
9
18 In Wind Splitter Quick Release
57400338
10
49mm Quick Release Clamp Assembly (4)
57192-05A
11
Inner Windshield Brace
57300171
12
Outer Windshield Brace
57300172
13
Windshield Brace Tape (2)
58052-78
14
EDPM Windshield Mounting Washer (4)
58152-96
15
Tool Less Release Windshield Mounting Hardware (4)
58790-04
16
Acorn Nut (9)
7651A
57400327
1
Pan Head Machine Screws (7)
2921A
2
Pan Head Machine Screws (2)
2452
3
N/A
N/A
4
Vertical Adhesive Tape (2)
11100168
5
RH Windshield Vertical Brace
57300103
6
LH Windshield Vertical Brace
57300104
7
RH Windshield Mount Bracket
57300105
8
LH Windshield Mount Bracket
57300106
9
18 In Wind Splitter Quick Release
57400338
10
49mm Quick Release Clamp Assembly (4)
57192-05A
11
Inner Windshield Brace
57300171
12
Outer Windshield Brace
57300172
13
Windshield Brace Tape (2)
58052-78
14
EDPM Windshield Mounting Washer (4)
58152-96
15
Tool Less Release Windshield Mounting Hardware (4)
58790-04
16
Acorn Nut (9)
7651A
57400331
1
Pan Head Machine Screws (7)
2921A
2
Pan Head Machine Screws (2)
2452
3
N/A
N/A
4
Vertical Adhesive Tape (2)
11100168
5
RH Windshield Vertical Brace
57300103
6
LH Windshield Vertical Brace
57300104
7
RH Windshield Mount Bracket
57300105
8
LH Windshield Mount Bracket
57300106
9
14 In Lt Smoke Wind Splitter Windshield
57400339
10
49mm Quick Release Clamp Assembly (4)
57192-05A
11
Inner Windshield Brace
57300171
12
Outer Windshield Brace
57300172
13
Windshield Brace Tape (2)
58052-78
14
EDPM Windshield Mounting Washer (4)
58152-96
15
Tool Less Release Windshield Mounting Hardware (4)
58790-04
16
Acorn Nut (9)
7651A
57400333
1
Pan Head Machine Screws (7)
2921A
2
Pan Head Machine Screws (2)
2452
3
N/A
N/A
4
Vertical Adhesive Tape (2)
11100168
5
RH Windshield Vertical Brace
57300103
6
LH Windshield Vertical Brace
57300104
7
RH Windshield Mount Bracket
57300137
8
LH Windshield Mount Bracket
57300138
9
18 In Lt Smoked Wind Splitter Windshield
57400343
10
49mm Quick Release Clamp Assembly (4)
57192-05A
11
Inner Windshield Brace
57300171
12
Outer Windshield Brace
57300172
13
Windshield Brace Tape (2)
58052-78
14
EDPM Windshield Mounting Washer (4)
58152-96
15
Tool Less Release Windshield Mounting Hardware (4)
58790-04
16
Acorn Nut (9)
7651A
57400336
1
Pan Head Machine Screws (7)
2921A
2
Pan Head Machine Screws (2)
2452
3
N/A
N/A
4
Vertical Adhesive Tape (2)
11100168
5
RH Windshield Vertical Brace
57300103
6
LH Windshield Vertical Brace
57300104
7
RH Windshield Mount Bracket
57300137
8
LH Windshield Mount Bracket
57300138
9
14 In Lt Smoke Wind Splitter Windshield
57400339
10
49mm Quick Release Clamp Assembly (4)
57192-05A
11
Inner Windshield Brace
57300171
12
Outer Windshield Brace
57300172
13
Windshield Brace Tape (2)
58052-78
14
EDPM Windshield Mounting Washer (4)
58152-96
15
Tool Less Release Windshield Mounting Hardware (4)
58790-04
16
Acorn Nut (9)
7651A
57400337
1
Pan Head Machine Screws (7)
2921A
2
Pan Head Machine Screws (2)
2452
3
N/A
N/A
4
Vertical Adhesive Tape (2)
11100168
5
RH Windshield Vertical Brace
57300103
6
LH Windshield Vertical Brace
57300104
7
RH Windshield Mount Bracket
57300105
8
LH Windshield Mount Bracket
57300106
9
18 In Lt Smoked Wind Splitter Windshield
57400343
10
49mm Quick Release Clamp Assembly (4)
57192-05A
11
Inner Windshield Brace
57300171
12
Outer Windshield Brace
57300172
13
Windshield Brace Tape (2)
58052-78
14
EDPM Windshield Mounting Washer (4)
58152-96
15
Tool Less Release Windshield Mounting Hardware (4)
58790-04
16
Acorn Nut (9)
7651A