REAR BRAKE ROTOR (DISC) KITS
J050592014-04-15
GENERAL
Kit Numbers
41832-05A, 42158-07A, 44102-95A, 44108-95A, 44357-00A, 44359-00A, 44366-00A, 44368-00A, 44421-09A, 44706-03A, 44822-00A, 44857-02A, 45047-06A, 46641-07A, 46777-09A, 48979-10, 41500005, 41500038, 41500069, 41500097, 41500109, 41500110
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Loctite® 243, Threadlocker and Sealant - Blue (99642-97).
Installation on FXSTD 17-inch wheels requires a separate purchase of Hub Plate Kit (43837-00).
For Kits 44102-95A and 44108-95A:
  • This brake disc must be used ONLY with brake pad kit (44209-87C). If that brake pad kit is not used, the disc will be damaged and its useful life shortened.
  • Brake pad kit 44209-87C is original equipment on 1992 and later models and must be used on those models. 1991 and earlier models also must use brake pad kit 44209-87C. These pads are identified by the number 56 stamped into the outside brake pad backing surface, opposite the friction material.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
See Table 1.
INSTALLATION
1.
Refer to the service manual for brake disc removal and disassembly procedures.
NOTICE
Do not re-use brake disc/rotor screws. Re-using these screws can result in torque loss and damage to brake components. (00319c)
2.
Assemble and install the new brake disc following the instructions in the service manual. Place a few drops of Loctite 243 (blue) on the threads of the new chrome screws from the kit. Install the brake disc using ONLY the new chrome screws. Tighten screws to 54 N·m (40 ft-lbs).
NOTE
Avoid hard stops for the first 300 miles. Hard stops during wear-in period will gall brake discs.
SERVICE PARTS
Table 1. Service Parts: Rear Brake Rotor (Disc) Kits
Item
Description (Quantity)
Part Number
1
Brake rotor, rear
Not Sold Separately
2
Screw, chrome (5)
4563