RIDER FOOTBOARD KIT
J065122018-08-21
GENERAL
Kit Number
50500869, 50500872 (footboard kit)
50500928, 50500929, 50500930, 50500931 (trim kits)
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
NOTE
There may be decreased access to the jiffy stand tab on Softail models.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
Kit Contents
See Figure 2 and Table 1.
INSTALLATION
1.
See Figure 1. Remove e-clip (3), clevis pin (1), and return spring (2). Remove footboard. Save hardware for installation.
2.
Clean and inspect footboard brackets. Replace if worn, rusted or damaged.
3.
Install footboard.
a.
Insert the short end of the torsion spring (2) into the forward most hole in the footboard.
b.
While holding the spring in place, install the footboard and spring onto the mounting bracket.
c.
Install clevis pin (1).
d.
Install e-clip (3).
e.
Rotate the footboard up and push the torsion spring into the slot on the mounting bracket.
1Clevis pin
2Torsion spring
3E-clip
Figure 1. Rider Footboard Installation
4.
Check that footboard pivots freely on clevis pin.
5.
Repeat for opposite side.
NOTE
Avoid contacting chrome surfaces with abrasive materials (stones, sand, etc.) as damage will result.
INSTALL OR REPLACE TRIM
1.
Remove screws.
2.
Replace trim.
3.
Apply threadlocker and install screws. Tighten.
Torque: 2.26–3.39 N·m (20–30 in-lbs)
LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
REPLACE WEAR PEG
1.
Remove screws.
2.
Replace wear peg.
3.
Apply threadlocker and install screws. Tighten.
Torque: 1.8–2.26 N·m (15.9–20.0 in-lbs)
LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
SERVICE PARTS
Figure 2. Service Parts: Rider Footboard
Table 1. Service Parts Table
Item
Description (Quantity)
Part
Number
1
Rider Footboard Assembly, right (black)
Not Sold Separately
2
Rider Footboard Assembly, left (black)
Not Sold Separately
3
Rider Footboard Insert, (2)
Not Sold Separately
4
Screw, Stainless SHCS (4)
10200658
5
Screw, Stainless SHCS (4)
10200659
6
Wear Peg (2)
50501013