License Plate Hardware Kit
Kit Number
94114-02 and 94546-05
These kits are designed to fit all license plate brackets that use 1/4 inch screws to fasten the license plate to the license plate bracket.
Kit Contents
Table 1. Kit Contents
Description (Quantity)
Part Number
Not sold
Screw, 1/4-20 x 0.5 in. (4)
Not sold
Lockwasher (4)
Nut, 1/4-20 (4)
1. Remove and discard the hardware fastening the license plate to the license plate bracket.
2. See Figure 1 and 2. Insert a screw (3) through a mounting hole in the front of the license plate and bracket.
3. From behind the license plate bracket, loosely fasten a lockwasher (2) and nut (1) to the screw.
4. Repeat steps 2 and 3 for all mounting holes in the license plate and bracket.
5. Use the wrench (4) to hold the screw heads straight while securely tightening the nuts behind the license plate bracket.
11/4-20 nut
21/4 inch lockwasher
3Screw (Bar & Shield version shown)
4Wrench (Bar & Shield version shown)
Figure 1. License Plate Hardware
11/4-20 nut (not shown)
21/4 lockwasher (not shown)
3Screw (Skull version shown)
4Wrench (Skull version shown)
Figure 2. License Plate Hardware