SEAT BUMPER KIT
J037122005-05-18
GENERAL
Kit Number
51653-06
Models
This kit is designed to fit 2006 and later Dyna model motorcycles with an original equipment (OE) solo seat. This kit is required to install 2-up seats on FXD and FXDB.
Additional Parts Required
NOTE
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
Table 1. Kit Contents
Description (Quantity)
Part Number
Seat Bumpers (4)
Not Sold Separately
Template (1)
Not Sold Separately
INSTALLATION
1.
Remove OE seat assembly.
2.
Thoroughly wash rear fender with soap and water.
3.
Rinse with clear water and dry with a clean cloth.
4.
Swab the fender with isopropyl alcohol and dry thoroughly.
5.
Cut template in half along dotted line.
6.
Cut out seat bumper locating squares.
7.
See Figure 1. Position rear half of template (3) on fender, align locating hole (1) on template with existing hole in rear of fender.
8.
Gather two seat bumpers (2) from kit. Remove the paper backing to expose the adhesive. Press the seat bumpers firmly into place.
9.
Remove rear half of template from fender.
10.
See Figure 2. Position front half of template (3) on fender, align locating hole (1) on template with existing hole in front of fender.
11.
Gather two seat bumpers (2) from kit. Remove paper backing to expose the adhesive. Press the seat bumpers firmly into place.
1Locating hole
2Seat bumpers
3Rear half of template
Figure 1. Rear Half of Template
1Locating hole
2Seat bumpers
3Front half of template
Figure 2. Front Half of Template
12.
Remove template from fender.
13.
Install seat.
WARNING
After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b)