TRIKE MUDFLAP KIT
J046682012-02-02
GENERAL
Kit Number
83833-09, 59600019
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 4 and Table 1.
INSTALLATION
1.
See Figure 1. Center drilling template on the rear fender. Adjust template to the bottom edge of the fender and tape template to fender.
2.
Center punch the two template drilling locations.
NOTE
Use caution to prevent damage to the tire when drilling the attachment holes for the mudflaps.
3.
Use a 17/64 (.266) inch bit to drill the template holes.
4.
See Figure 2. Install the mudflap using one stud, washer and nut in each fastening hole. Tighten to 6.8–13.6 N·m (5–10 ft-lbs).
5.
Repeat Steps 1-4 for the opposite fender.
1Template
2Drilling locations
Figure 1. Attaching Template
1Stud
2Washer
3Nut
Figure 2. Mudflap Hardware
Figure 3. Installed Mudflap
SERVICE PARTS
Figure 4. Service Parts: FLHTCUTG Mudflap Kit
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Mudflap template
Not Sold Separately
2
Fender mudflap (2)
Not Sold Separately
3
Stud, 1/4-20 (4)
8310
4
Flat washer (4)
6036
5
Hex nut (4)
7688