Chrome Forward Control Bracket Kit
J064392017-08-22
GENERAL
Kit Number
50500693
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is available from a Harley-Davidson Dealer.
KIT CONTENTS
See Figure 5 and Table 1.
REMOVAL
Remove right side forward control bracket and left side forward control bracket. See service manual.
INSTALLATION
RIGHT SIDE
1. See Figure 1. Position right side forward control bracket (1).
1Right side forward control bracket
2Torx head button screws
Figure 1. Right Side Forward Control
2. Install two 3/8-16 x 1.625 torx head button screws (2). Tighten.
Torque: 54.2–61 N·m (40–45 ft-lbs)
3. See Figure 3. Insert short leg of torsion spring (1) into hole in footpeg (3). Align long leg of torsion spring (1) to hole in footpeg mount and insert. Rotate footpeg (3) into position in clevis and insert pin (4) through clevis, footpeg (3) and spring (1). Install retaining clip (2).
NOTE
See Figure 2. When performing the next step, verify that the spring is positioned inside of the footpeg.
Figure 2. Torsion Spring
1Torsion spring
2Retaining clip
3Footpeg assembly
4Pin
Figure 3. Rider Footpeg Torsion Spring Installation
LEFT SIDE
1. See Figure 4. Position left side forward control bracket (1).
1Pin
2Left side forward control bracket
3Shifter lever
4Torx head button screws
5Retaining clip
6Torsion spring
7Footpeg assembly
8Pinch bolt
9Washer (if equipped)
10Shift lever assembly
11Spacer
12O-rings
13Bearings (part of left side forward control bracket)
Figure 4. LEFT SIDE FORWARD CONTROL
2. Install two 3/8-16 x 1.625 torx head button screws (4). Tighten.
Torque: 54.2–61 N·m (40–45 ft-lbs)
3. Verify inner o-ring (12) is in place on shifter lever (3) and position shifter lever in left side forward control bracket (2).
4. Install outer o-ring (12) and spacer (11) on shifter lever (3).
5. Install shifter assembly (10), install pinch bolt (8) and washer (9). Tighten.
Torque: 12.2–16.2 N·m (9–12 ft-lbs)
6. See Figure 4. Insert short leg of torsion spring (6) into hole in footpeg (7). Align long leg of torsion spring (6) to hole in footpeg mount and insert. Rotate footpeg (7) into position in clevis and insert pin (1) through clevis, footpeg (7) and spring (6). Install retaining clip (5).
NOTE
See Figure 2. When performing the next step, verify that the spring is positioned inside of the footpeg.
SERVICE PARTS
Figure 5. Service Parts: Chrome Forward Control Bracket Kit
Table 1. Service Parts: Chrome Forward Control Bracket Kit
Item
Description (Quantity)
Part Number
1
3/8-16 x 1.625 Chrome torx head button screws (4)
10200536
2
Chrome left side forward control bracket
33600212
3
Chrome right side forward control bracket
50500913