TRANSMISSION SIDE COVERS: HYDRAULIC
J060902019-08-21
GENERAL
Kit Number
34800026, 25800063, 25800065, 25800087, 25800130, 25800132
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Separate purchase and installation of additional parts or accessories may be required for proper installation of this kit on your model motorcycle. Please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only) for a list of required parts or accessories for your model.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
INSTALLATION
NOTE
  • For vehicles equipped with security siren: With security fob present, turn ignition switch ON. See the service manual. After system is disarmed, turn ignition switch OFF. IMMEDIATELY remove the main fuse.
  • For vehicles WITHOUT security siren: Remove the main fuse. See the service manual.
1.
Remove seat. See the service manual.
WARNING
To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)
2.
Remove main fuse. See the service manual.
3.
Loosen or remove components necessary to access transmission side cover.
4.
See Figure 1. Remove outer transmission side cover (2).
1Inner side cover
2Outer transmission side cover
3Side cover screw (2)
4Grommet
Figure 1. Transmission Side Covers
5.
Install outer transmission side cover. Tighten screws:
Torque: 11.2–13.6 N·m (100–120 in-lbs) Hex socket head screw.
6.
Verify that clutch fluid line grommet is seated securely between the inner side cover and the outer side cover.
7.
Tighten or install components that were loosened or removed.
8.
Install main fuse. See the service manual.
9.
Install seat. After installing seat, pull up on the seat to verify that it is secure. See service manual.
INSERT INSTALLATION (Optional)
1.
See Figure 4. Remove screw (2) from insert pockets and retain.
2.
Install insert (A) with screws (2). Tighten.
Torque: 2.03 N·m (18 in-lbs)
SERVICE PARTS
Figure 2. Burst Transmission Side Cover (for kit 34800026)
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Outer transmission side cover
Not Sold Separately
2
Washer (2)
94062-03
3
Screw (2)
94316-91TS
Figure 3. Transmission Side Cover
Table 2. Service Parts
Item
Description (Quantity)
Part Number
1
Outer transmission side cover
Not Sold Separately
2
Medallion
14100874
Figure 4. Dominion Transmission Side Cover
Table 3. Service Parts: Kits 25800130, 25800132
Item
Description (Quantity)
Part Number
1
Transmission Cover
Not sold separately
2
Screw (2)
10200659
Service parts required sold separately
A
Insert:
Black
61400598
Black w/HDMC
61400609
Bronze
61400602
Orange
61400606