Accessory Footboard Inserts
J065062019-08-21
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
50500722, 50500718, 50500729, 50500732, 50501283, 50501284, 50501396, 50501398, 50501400, 50501401
Screwdriver, Liquid dishwashing soap
0.75 h
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Footboard Insert Kits (typical)
Table 2. Kit Contents: Footboard Insert Components
Item
Description
Part No.
1
Footboard, rider, right side
Not sold separately
2
Footboard, rider, left side
Not sold separately
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Kit Number
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
INSTALLATION
Remove Existing Footboard Inserts
1. Apply liquid dishwashing soap to the footboard insert rubber bulbs protruding through the bottom of the footboard.
2. Insert screwdriver into hole in underside of bulb and push bulb through footboard pan. Alternately, use a small screwdriver to work bulb through pan.
Install New Footboard Inserts
1. Apply liquid dishwashing soap to the new footboard insert rubber bulbs.
2.
NOTE
Medallion of Ride Free inserts should be toward rear of bike.
Place the footboard insert into position on the footboard.
3. Use pliers to pull each rubber bulb into its footboard hole until the bulbs protrude through the footboard.
4. Repeat the above steps for the remaining footboard insert.