LIVEWIRE PREMIUM GRIPS
J066512019-08-21
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
56100330
Safety Glasses
1 h
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Handlebar Grip Components (Generic Style Shown)
Table 2. Handlebar Grip Components
Item
Qty
Description
Part No.
Notes
1
1
Grip, right side
56100349
2
1
Grip, left side
56100354
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
PREPARE
1. Remove top cover. See service manual.
2. Remove main fuse. See service manual.
REMOVE
Left
1. See Figure 2. Remove mirror and bracket. See service manual.
2. Remove left handlebar switch housing. See service manual.
3. Remove left hand grip.
a. Cut hand grip open with a sharp knife.
b. Peel hand grip open.
c. Remove grip from handlebar.
1Switch housing screw (2)
2Housing
3Handlebar clamp
4Left handlebar grip
Figure 2. Left Handlebar Switch Housing
Right
4. Detach front brake master cylinder from handlebar. See service manual.
5. Remove right hand switch housing. See service manual.
6. Remove right hand grip.
INSTALL
Left
1. Install left hand grip.
a. Prepare left grip end of handlebar with emery cloth.
b. Clean left grip end of handlebar with acetone.
c. Position new hand grip so the larger diameter portion of flange is at the bottom.
d. Push grip (4) fully onto handlebar.
2. Install left handlebar switch housing. See service manual.
NOTE
Ensure grip is properly secured between the two halves of the switch housing by verifying there are no gaps between the upper and lower housings. Grip should not move relative to the switch housings when it is pulled or twisted.
3. Install mirror and bracket. See service manual.
Right
4. Install hand grip with cosmetic features properly positioned.
a. Rotate to verify that internal splines are engaged with twist grip sensor.
5. Install right hand switch housing. See service manual.
6. Install front brake master cylinder to handlebar. See service manual.
COMPLETE
1. Install main fuse. See service manual.
2. Install top cover.