LOW PROFILE 2UP SEAT, LIVEWIRE
J068012019-08-21
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
52300427
Safety Glasses, Torque Wrench
1.5 h
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Low-Profile Seat
Table 2. Kit Contents: Low-Profile Seat Components
Item
Qty
Description
Part No.
Notes
1
Seat
Not sold separately
2
Rear cover
Not sold separately
3
Grab strap
Not sold separately
Items not shown but included in kit
2
Screw
3731M
7–11 N·m (62–97 in-lbs)
2
Washer
6837M
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
PREPARE
1. Remove main fuse. See the owner's manual.
a. Place OFF/RUN switch in OFF position.
b. Remove top cover.
c. Remove main fuse.
REMOVE
1. See Figure 2. Remove rear cover.
a. Raise seat.
b. Remove screws (1).
c. Remove rear cover.
2. See Figure 3. Remove seat.
a. Remove E-clip (9).
b. Remove washer (4) and spring (3) with lock pin (2).
c. Remove screws (7).
d. Separate subframe (6) to allow removal of crossmember (8) and seat (1).
3. Remove crossmember from seat.
1Screw (2)
2Rear cover
Figure 2. Rear Cover
1Seat
2Lock pin
3Spring
4Washer
5Cord caddy
6Subframe
7Screw (2)
8Crossmember
9E-clip
Figure 3. Seat Attachment
INSTALL
1. See Figure 3. Install crossmember (8) in seat (1).
2.
NOTE
Crossmember (8) and subframe (6) have flats at mating surfaces. Rotate crossmember so flats are aligned during install.
Install seat.
a. Separate subframe (6) to alow installation of crossmember (8) and seat (1).
b. Install screws (7). Tighten.
Torque: 5–6.5 N·m (44–58 in-lbs)
c. Install lock pin (2) with spring (3) and washer (4).
d. Install E-clip (9).
3. See Figure 2. Install rear cover.
a. Install rear cover (2).
b. Install screws (1). Tighten.
Torque: 2–4 N·m (18–35 in-lbs)
c. Lower seat.
COMPLETE
1. Install main fuse. See the owner's manual.
a. Install main fuse.
b. Install top cover.