OVERWATCH HANDLEBAR BAG, SMALL
J068042019-08-19
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
93300121
Safety Glasses
15 min
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Overwatch Handlbar Bag Components
Table 2. Kit Contents: Overwatch Handlbar Bag Components
Item
Qty
Description
Part No.
Notes
1
1
Bag, handlebar, small
Not sold separately
2
6
Hook-and-Loop
93500026
3
1
Anti-abrasion tape
Not sold separately
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
PREPARE
1. Cut anti-abrasion tape (3) to fit area being applied to.
a. Nacelle
b. Headlight bracket
INSTALL
WARNING
Do not exceed Handlebar Bag weight capacity. Too much weight in Handlebar Bag can cause loss of control, which could result in death or serious injury. (06705a)
NOTE
Weight of contents must not exceed weight limit of 2.5 lbs (1.1 kg).
1. See Figure 2. Attach a minimum of four hook-and-loops to back of bag.
2. See Figure 3. Secure hook-and-loops on bag to handlebar (2) and risers (3).
NOTE
  • When installing hook-and-loops to risers and handlebar be careful not to pull on, squeeze or pinch any wiring or cables.
  • Verify full range of movement by turning handlebars lock-to-lock.
  • Verify that bag does not cover up lighting, turn signals, reflectors, instruments cluster or warning lights.
  • Depending on vehicle model and configuration, bag can be mounted in front of or behind handlebars.
3. Tighten hook-and-loops as much as possible.
4. Trim excess hook-and-loop straps once installed.
5. Periodically recheck mounting straps and cargo.
1Vertical install through strap
2Horizontal install through clip
Figure 2. Hook-and-Loop Attachment Options
1Bag
2Handlebar
3Risers
Figure 3. Bag and Hook-and-Loop Attachment
CARE AND MAINTENANCE INSTRUCTIONS
1. Use a lint free cloth to wipe off any dust or dirt.
2. Thoroughly clean outer surface with warm water and a mild detergent.
3. Do not use artificial means to dry material quickly.
4. Contains one or more of the following materials:
a. Polyester
b. Polypropylene
c. Polyethylene