ENDGAME COLLECTION RIDER
J067732020-01-14
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
50501641, 50501684
Safety Glasses, Torque Wrench, E-Clip tool
1 h
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Endgame Collection Rider Components
Table 2. Kit Contents: Endgame Collection Rider Components
Item
Qty
Description
Part No.
Notes
1
1
Footpeg, rider right side, graphite
50501685
1
Footpeg, rider right side, black
50501686
2
1
Footpeg, rider left side, graphite
50501687
1
Footpeg, rider left side, black
50501688
3
2
Wear peg
50501135
NOTE
Verify that all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
1. See Figure 2. Remove pin (4) and E-clip (2). Retain for later use.
2. Save all hardware including torsion spring (1) for installation of new footpegs (3).
INSTALL
1. See Figure 2 and Figure 3. Insert short leg of torsion spring (1) into hole in new footpeg (3).
NOTE
When performing the next step, verify that the torsion spring is positioned inside of the footpeg.
2. Align long leg of torsion spring (1) to hole in footpeg mount and insert.
3. Rotate footpeg (3) into position in clevis and insert pin (4) through clevis, footpeg (3) and torsion spring (1).
4. Install E-clip (2).
5. Repeat steps for other side.
Wear Tip Replacement
1. When servicing wear tip, remove existing wear tip from footpeg.
2. Apply two or three drops of threadlocker to threads of new wear tip.LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
3. Install new wear tip to footpeg.
Torque: 3.38–4.74 N·m (30–42 in-lbs)
1Torsion spring
2E-clip
3Footpeg
4Pin
Figure 2. Rider Footpeg Torsion Spring Installation
Figure 3. Torsion Spring