80GRIT™ FOOTBOARD KIT - RIDER - SOFTAIL
941000392020-01-14
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
50501612, 50501613
Safety Glasses
1 h
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rider Footboard Components
Table 2. Kit Contents: Rider Footboard Components
Item
Qty
Description
Part No.
Notes
1
2
Footboard, rider, assembly, raw
50501622
Kit 50501612
Footboard, rider, assembly, black
50501623
Kit 50501613
2
2
Footboard, trim assembly, raw
50501818
Kit 50501612
Footboard, trim assembly, black
50501817
Kit 50501613
3
16
Screw
10200913
Kit 50501612
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
NOTE
There may be decreased access to the jiffy stand tab on Softail models.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
REMOVE
1. See Figure 2. Remove footboard.
a. Remove e-clip (3), clevis pin (1), and torsion spring (2).
b. Save hardware for installation.
INSTALL
1. Clean and inspect footboard brackets. Replace if worn, rusted or damaged.
2. See Figure 2. Install footboard.
a. Insert short end of torsion spring (2) into notch in footboard.
b. While holding torsion spring (2) in place, install footboard and spring onto mounting bracket.
c. Install clevis pin (1).
d. Install E-clip (3).
1Clevis pin
2Torsion spring
3E-clip
Figure 2. Rider Footboard Installation
NOTE
Avoid contacting chrome surfaces with abrasive materials (stones, sand, etc.) as damage will result.
REPLACE TRIM ASSEMBLY
1. See Figure 1. Remove screws (3).
2. Remove trim assembly (2).
3. Clean all threadlocker from screws and threaded holes.
4. Apply threadlocker to threads of screws.LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
5. Install new trim assembly.
6. Install all screws.
7. Tighten screws.