Footpeg Kit
Kit Number
50211-04, 50500367, 50501800
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of (English only).
Installation Requirements
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
See Figure 2 and Table 1.
1. Remove the hardware fastening the stock footpeg to the motorcycle footpeg support. Save the hardware for installation.
2. Remove the stock footpeg and spring washer from the motorcycle footpeg support. Note the orientation of, and save, the spring washer for installation.
See Figure 2. When installing the footpeg-support mount (1) on the motorcycle footpeg support, the rounded edge of the footpeg-support mount must be positioned upward.
When installing the spring washer, position the spring washer with the square edge toward the inside of the footpeg support.
3. Slide a new footpeg mount and stock spring washer into the footpeg support.
4. Install new footpeg mount in reverse order of stock footpeg mount removal.
See Figure 2. When replacing the footpeg support mount (1), either replace the screw (4), or apply LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97) to the threads on the removed screws before re-installing the screws.
a. Vehicles with a nut and bolt on the footpeg support, tighten fastener. Tighten.
Torque: 26 N·m (19 ft-lbs)
5. Assemble footpeg (2) and footpeg pad (3) onto footpeg mount (1).
6. Install the adjusting screw through the peg and into the mount.
7. Rotate the footpeg assembly to the desired position.
8. Tighten the adjusting screw. Tighten.
Torque: 29 N·m (21 ft-lbs)
9. Repeat Steps 1 through 6 for the other footpeg.
Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a)
1Spring washer
Figure 1. Footpeg Spring Washer Installation
Service Parts
Figure 2. Service Parts: Footpeg Kit
Table 1. Service Parts Table
Description (Quantity)
Part Number
Mount (2) (For Kit 50211-04)
Mount (2) (For kit 50501800)
Mount (2) (For kit 50500367)
Not Sold Separately
Support (2) (For Kit 50211-04)
Support (2) (For kit 50501800)
Support (2) (For kit 50500367)
Not Sold Separately
Pad (2) (For Kit 50211-04)
Pad (2) (For kit 50501800)
Pad (2) (For kit 50500367)
Not Sold Separately
Screw, hex socket head (2)