BRAKE PEDAL PAD KIT, LARGE
J029362020-01-14
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
42712-04, 50600417
Safety Glasses, Torque Wrench
1 h
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Chrome Brake Pedal Pad Kit - Large Components
Table 2. Kit Contents: Chrome Brake Pedal Pad Kit - Large Components
Item
Qty
Description
Part No.
Notes
1
1
Cover,brake pedal, chrome
42410-04
1
Cover,brake pedal, black (Kit 50600417)
50600245
2
1
Pad, brake pedal
42444-04
3
1
Shoulder washer, nylon Washer, flat, offset
6421
4
1
Locknut, acorn, high crown
7946
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
This kit is designed for installation on 1986 and later FLHT/C/CI/CUI, FLTR/I, FLHR/I/CI model motorcycles.
This kit can be used with Rider Footboard Kit (50631-04).
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
WARNING
Brakes are a critical safety component. Contact a Harley-Davidson dealer for brake repair or replacement. Improperly serviced brakes can adversely affect brake performance, which could result in death or serious injury. (00054a)
REMOVE
1. Remove previously installed brake pedal cover (1) from motorcycle.
INSTALL
1. Position and slide new brake pedal cover (1) over brake pedal.
2. Align and install new brake pedal pad (2) with 5/16-18 stud and insert it through brake pedal cover (1) and brake pedal.
3. Install acorn locknut (4) and washer (3) on stud. Tighten.
Torque: 26 N·m (19 ft-lbs)