GEAR SHIFT LEVER
941000992020-01-14
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
33600318
Safety Glasses, Torque Wrench
1 h
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rider Backrest Components
Table 2. Kit Contents: Rider Backrest Components
Item
Qty
Description
Part No.
Notes
1
1
Lever
Not sold separately
2
1
Screw
4387
3
1
Nut
7686
4
1
Nut
7727
5
1
Screw
10200350
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
REMOVE
1. See Figure 2. Remove screw to free linkage from front shifter rod lever (1).
2. Mark position of foot shift lever in relation to shaft.
3. Forward Foot Control Models:
a. Remove pinch screw (7) and nut (8).
b. Remove foot shift lever assembly.
c. Remove shifter rod lever and shaft.
INSTALL
1. Forward Foot Control Models:
a. Install shifter rod lever (1) and shaft.
b. Install foot shift lever, aligning to marks made during removal.
c. Install pinch screw (7) and nut (8). Tighten.
Torque: 12.2–16.3 N·m (9.0–12.0 ft-lbs)
d. Connect shifter rod. Tighten.
Torque: 13.6–19 N·m (120.4–168.2 in-lbs)
2. Secure linkage to shifter rod lever (1). Tighten.
Torque: 13.6–19 N·m (120.4–168.2 in-lbs)
3. Verify shifter rod operation.
1Shifter rod lever, front
2Nut
3Shifter rod
4Shifter rod lever, rear
5Screw
6Screw
7Pinch screw
8Nut
Figure 2. Shift Linkage: Forward Control Models