BRAKE RESERVOIR COVER
J067492021-01-19
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
61301075
Safety Glasses, Torque Wrench
30 min
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rear Brake Reservoir Cover Components
Table 2. Kit Contents: Rear Brake Reservoir Cover Components
Item
Qty
Description
Part No.
Notes
1
2
Screw
10200425
2
2
Washer
10300194
3
1
Cover
Not sold separately
4
2
Washer, flat
6701
5
2
Washer, spring
10600061
6
2
Spacer, cover
61301120
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Ensure you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
1. See Figure 2. Remove Original Equipment (OE) screws (1) from rear brake cylinder.
Figure 2. OE Screw Removal from Rear Brake Cylinder
INSTALL
NOTE
Verify spacers (61301120) are aligned with holes in carbon fiber trim prior to tightening screws (10200892).
1. See Figure 1. Install assembled cover to rear brake cylinder using new screws (1). Tighten.
Torque: 8–10 N·m (71–89 in-lbs)