SIGNATURE LED TURN SIGNAL INSERT
941000132021-01-13
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
67801147, 67801148, 67801149, 67801150, 67801184, 67801186
Safety Glasses, Flat head screwdriver
15 min
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Signature LED Turn Signal Insert Components (Kit 67801148 shown)
Table 2. Kit Contents: Signature LED Turn Signal Insert Components
Item
Qty
Description
Part No.
Notes
1
2
LED turn signal assembly
Not sold separately
Front: 67801147, 67801148, 67801184, 67801186
Rear: 67801149, 67801150
NOTE
Verify that all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
1. See Figure 2. Remove Original Equipment (OE) lens (1).
2. Remove bulb (2).
1Lens
2Bulb
3Bullet housing
Figure 2. OE Lens and Bulb Removal (Front Shown, Rear Similar)
INSTALL
1. See Figure 4. Install connector end of LED assembly (1) to bullet housing (2).
2. See Figure 3. Align LED assembly so that hinge (1) is in the 12 o'clock position and drain hole (2) in the six o'clock position.
3. See Figure 4. Install hinge into groove at top of bullet housing (2) and swing bottom of LED assembly (1) into bullet housing.
4. Snap into place. Two snaps should be heard for full insertion.
5. Repeat for other side.
1Hinge, 12 o'clock position (wide opening)
2Drain hole, six o'clock position (narrow opening)
Figure 3. Hinge/Slot Location
1LED assembly
2Bullet housing
Figure 4. LED Assembly Install (Front Shown, Rear Similar)
COMPLETE
1. Check operation of all lamps.