SCREAMIN' EAGLE TIMER COVER - MILWAUKEE EIGHT
J066892018-08-20
GENERAL
Kit Numbers
25600117
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
See Figure 2 and Table 1.
INSTALLATION
1. See Figure 2. Remove original equipment (OE) screws and timer cover.
2. See Figure 1 for orientation of timer cover and insert. Place new timer cover (1) in position and secure with (OE) screws (2).
3. Secure screws. Tighten.
Torque: 2.8–3.9 N·m (25–35 in-lbs) screw
Timer Cover Insert Installation
NOTE
Timer cover inserts are sold separately. Refer to Table 1.
1. Clean insert surface area with a mixture of 50 to 70% isopropyl alcohol and 30 to 50% distilled water. Allow to dry thoroughly.
2. Peel liner from adhesive backing of timer cover insert (3).
3. Position insert over timer cover (1) without touching adhesive on timer cover insert surface.
4. Line up insert with recess timer cover.
5. Press timer cover insert firmly against the cover all around, and hold pressure for 30 seconds.
6. After releasing pressure, avoid direct contact with the insert for about 20 minutes.
NOTE
Allow at least 24 hours after applying the insert before exposing the area to vigorous washing, strong water spray or extreme weather. The adhesive bond will increase to maximum strength after about 72 hours at normal room temperatures.
Replacement of Timer Cover Insert
To remove an existing timer cover insert, carefully insert a screwdriver (or similar tool) between the insert and timer cover at the bottom edge. Then pry the insert from the cover, being careful to not damage the cover during removal. See installation notes above to apply the new timer cover insert.
Assembly Orientation
1Timer cover
2Cover insert
Figure 1. Timer Cover Assembly
SPECIAL CARE INSTRUCTIONS
NOTE
To prevent damage to the chrome surface, do not use any detergents, chemical solvents, polishes or abrasive cleaning agents.
To keep this surface in best condition, lightly wipe with a MICROFIBER DETAILING CLOTH (94663-02) using clear water or a mild Harley-Davidson cleaner such as:
SERVICE PARTS
Figure 2. Service Parts: Timer Cover Kit
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Timer cover
Not Sold Separately
2
Screw (OE) (2)
68120-00
3
Timer cover insert, 107, Stage I
25600118
Timer cover insert, 107, Stage II
25600119
Timer cover insert, 114, Stage I
25600132
Timer cover insert, 114, Stage II
25600120
Timer cover insert, 114, Stage III
25600121
Timer cover insert, 114, Stage IV
25600122
Timer cover insert, 117, Stage II
25600123
Timer cover insert, 117, Stage III
25600124
Timer cover insert, 117, Stage IV
25600125