PASSENGER FOOT PEG KIT
J065282021-08-02
GENERAL
Kit Number
50500831, 50500832, 50500833, 50501830, 50501831, 50501832
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 2 and Table 1.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
INSTALLATION
NOTE
See Figure 1. When performing the next step, verify that spring (1) is positioned inside of footpeg (3).
1. See Figure 1. Vehicle has a pin (2) and E-clip (1). Remove them and retain for future use. Save all hardware, including detent spring (7), detent ball (6) and detent plate (5) for installation of the new footpegs (3).
2. Insert detent spring (7) into new footpeg (3), followed by detent ball (6). Position detent plate (5) on footpeg clevis edge while capturing detent ball (6) and detent spring (7) inside detent plate (5) while sliding detent plate (5) onto footpeg clevis.
3. Align detent plate (5) and footpeg (3) with footpeg mount on vehicle.
4. Install pin (2) and E-clip (1).
WARNING
Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a)
5. Defiance Passenger Pegs (only) - adjust orientation as follows:
a. Rotate to desired orientation.
b. Fold peg up to stowed position and confirm clearance to other components. Adjust as necessary.
c. Tighten adjustment screw.
Torque: 28.5 N·m (21 ft-lbs)
1E-clip
2Pin
3Stock passenger footpeg
4Support, footpeg
5Plate, detent
6Ball, detent
7Spring, detent
Figure 1. Footpeg Assembly
Service Parts
Figure 2. Service Parts
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Footpeg insert (black)
Not sold separately
2
Medallion (2)
14100879
3
Foot peg base (chrome)
Not sold separately
4
Footpeg mount (chrome)
Not sold separately
Figure 3. Service Parts: Passenger Footpeg
Table 2. Service Parts: Passenger Footpeg
Item
Description (Quantity)
Part Number
1
Footpeg, passenger, left (chrome)
50501822
Footpeg, passenger, left (black)
50501823
Footpeg, passenger, left (black edge cut)
50501824
2
Footpeg, passenger, right (chrome)
50501825
Footpeg, passenger, right (black)
50501826
Footpeg, passenger, right (black edge cut)
50501827