RIDER FOOTBOARD - TOURING
J067752021-08-02
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
50501649, 50501680, 50501932, 50501933, 50501934
Safety Glasses, Torque Wrench
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rider Footboard Components
Table 2. Kit Contents: Rider Footboard Components
Item
Qty
Description
Part No.
Notes
1
4
Screw
10200986
2
4
Locking nut, flange
7716
3
1
Footboard assembly, right side, graphite
50502093
Endgame Collection
1
Footboard assembly, right side, black
50502094
Endgame Collection
1
Footboard assembly, right side, chrome
50501926
Empire Collection
1
Footboard assembly, right side, black
50501928
Empire Collection
1
Footboard assembly, right side, machine cut
50501930
Empire Collection
4
1
Footboard assembly, left side, graphite
50502095
Endgame Collection
1
Footboard assembly, left side, black
50502096
Endgame Collection
1
Footboard assembly, left side, chrome
50501927
Empire Collection
1
Footboard assembly, left side, black
50501929
Empire Collection
1
Footboard assembly, left side, machine cut
50501931
Empire Collection
5
2
Wear peg
50501135
Endgame Collection
2
Wear peg
50500628
Empire Collection
NOTE
Verify that all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
1. Remove two hinge bolts and locknuts attaching the existing footboard to the mounting brackets.
2. Remove footboard.
3. Discard hardware.
INSTALL
1. See Figure 1. Set correct footboard in place over mounting brackets. Wear peg should be toward rear of vehicle.
2. Align holes and install pivot screws (1) and locking nuts (2).
3. Locking nuts should be on inboard side. Tighten.
Torque: 9–12 N·m (80–106 in-lbs)
4. Check that footboard pivots freely on hinge bolts.
5. Repeat for opposite side.
Wear Tip Replacement
1. When servicing wear tip, remove existing wear tip from footpeg.
2. Apply two or three drops of threadlocker to threads of new wear tip.LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
3. Install new wear tip to footpeg.
Torque: 3.38–4.74 N·m (30–42 in-lbs)