RIDER FOOTBOARD
J067762022-03-23
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
50501679, 50501648, 50501938, 50501939, 50501945
Safety Glasses, E-Clip tool
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rider Footboard Components
Table 2. Kit Contents: Rider Footboard Components
Item
Qty
Description
Part No.
Notes
1
2
Footboard Assembly, graphite
50502097
Footboard Assembly, black
50502098
2
1
Footboard, left, black
50501940
Footboard, left, machine cut
50501936
Footboard, left, chrome
50501948
3
1
Footboard, right, black
50501944
Footboard, right, machine cut
50501942
Footboard, right, chrome
50501947
4
2
Spring
50502463
Kits 50501938, 50501939, 50509145
Service Part
N/A
1
Wear peg
50500628
Kits 50501938, 50501939, 50509145
NOTE
Verify that all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
1. See Figure 2. Remove E-clip (3), clevis pin (1) and return torsion spring (2).
2. Remove footboard.
3. Save hardware for new footboard installation.
4. Clean and inspect footboard brackets.
5. Replace if worn, rusted or damaged.
INSTALL
1. Install footboard.
a. Kits 50501679, 50501648: See Figure 2. Insert short end of Original Equipment (OE) torsion spring (2) into forward most hole in footboard.
b. Kits 50501938, 50501939, 50501945: See Figure 1. Insert short end of new torsion spring (4) into forward most hole in footboard.
c. While holding torsion spring (2) in place, install footboard and torsion spring onto mounting bracket.
d. Install clevis pin (1).
e. Install E-clip (3).
f. Rotate footboard up and push torsion spring (2) into slot on mounting bracket.
2. Check that footboard pivots freely on clevis pin (1).
3. Repeat steps 1 and 2 on opposite side.
1Clevis pin
2Torsion spring
3E-clip
Figure 2. Rider Footboard Kit
Wear Peg Replacement
1. See Figure 3. Remove existing wear peg (1) from floorboard.
2. Apply 2 or 3 drops of threadlocker to threads of new wear peg (1) and install.LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
3. Tighten wear peg (1).
Torque: 3.4–4.8 N·m (30–42 in-lbs) Wear peg
1Wear peg
Figure 3. Floorboard Wear Peg (typical)