TRUNK MOUNT FLAG KITS
J057052017-08-22
GENERAL
Kit Numbers
61400205, 61400206, 61400522, 61400523
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
NOTE
Flags are not intended for highway use. The construction of these flags will not hold up to the wind speeds at highway speeds. These flags are designed for parade use only.
Kit Contents
Table 1. Kit Contents
Description (Quantity)
Part Number
Wear pads (2)
94620-98
Flag mast
Not Sold Separately
Flag mast retainer
Not Sold Separately
Rubber pad
61079-82
Flag
See Catalog
INSTALLATION
NOTE
  • Wear pads and rubber pads must be installed to avoid damage to the Tour-Pak. Periodically check the mast mounting to verify the mast remains in contact with mounting pads.
  • Water may enter Tour-Pak when flag mast is installed.
  1. See Figure 1. Remove adhesive backing from wear pad (1) and install on area where mast base will touch the painted portion of the Tour-Pak or Saddlebag. If Tour-Pak, attach second wear pad to light bar top taking care to align edge of wear pad to mounting surface of light bar and Tour-Pak.
  2. Attach flag mast to Tour-Pak or Saddlebag as shown.
  3. See Figure 2. Cut the self-adhesive rubber pad in half. Remove the backing from the rubber pads and install on the inside of the Tour-Pak or Saddlebag on each side of the flag mast (1).
1Wear pad
Figure 1. Install Wear Pad on Tour-Pak
1Rubber pad (2)
Figure 2. Install Rubber Pads on Interior of Tour-Pak