RIDER FOOTBOARD KIT
J028312020-01-14
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
50631-04, 50500089, 50501801
Safety Glasses, Torque Wrench
1 hour
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rider Footboards Components
Table 2. Kit Contents: Rider Footboards Components
Item
Qty
Description
Part No.
Notes
1
1
Footboard assembly, right
Not sold separately
2
1
Footboard assembly, left
Not sold separately
3
4
Shoulder bolt, 1/4-20 x 1-3/32 inch, Kit 50631-04 (Not shown)
50635-82A
4
4
Locknut, flanged, 1/4-20, Kit 50631-04 (Not shown)
7716
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
This kit is not compatible with Leather Rider Footboard Fringe Kits (50205-97) or (50206-98).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
1. Remove two shoulder bolts and locknuts attaching existing footboard to mounting brackets.
2. Remove the footboard.
3. Clean and inspect the footboard brackets. Replace if worn, rusted or damaged.
NOTE
For kit 50500089, use Original Equipment (OE) mounting hardware when installing footboards.
INSTALL
1. Install appropriate footboard (1 or 2) in place over mounting brackets.
2. Line up the holes and install shoulder bolts (3) and locknuts (4). Tighten.
Torque: 9–12 N·m (7–9 ft-lbs)
3. Check that footboard pivots freely.
4. Repeat procedure for opposite side.