Kit Number
Table 1. Kit Part Numbers
Kit Number
Battery cover trim, Skull logo
Battery cover trim, Harley-Davidson script
This kit fits 2006 and later Dyna models.
Kit Contents
See Figure 3 and Table 2.
  1. See Figure 3. Remove button-head screw (A) that attaches battery cover (B) to battery tray (C).
  2. See Figure 1. Remove battery cover by lifting it over the two tabs on the battery tray.
  3. NOTE
    The original equipment battery cover trim has four pinch tabs on the reverse side that attach it to the battery cover.
  4. See Figure 2. Remove original equipment battery cover trim from battery cover by pushing the four pinch tabs out of the battery cover using a pliers or suitable tool.
  1. Place battery cover over the two tabs on battery tray (C) and attach it to battery tray with button-head screw (A). Tighten screw to 20-40 in-lbs (2.3-4.6 Nm).
  2. Obtain chrome battery cover trim (1) from kit.
  3. Using a 50/50 isopropyl alcohol/water solution, thoroughly clean the surface where the chrome trim will be installed. Let it dry completely.
  4. NOTE
    Test the trim mount fit prior to removing the adhesive backing from the chrome battery cover trim.
  5. Remove adhesive liner from the chrome battery cover trim.
  6. NOTE
    The ideal temperature should be at least 60° F (16° C) for proper adhesion of the chrome trim on the battery cover.
  7. Center and install chrome trim onto the battery cover. Apply firm pressure for one minute using a cloth to prevent scratching the battery cover and battery trim.
  8. Let the adhesive cure for 24 hours at no less than 60° F (16° C).
Figure 1. Position of Tabs on Battery Tray
Figure 2. Push pinch tabs out of battery cover.
Service Parts
Figure 3. Service Parts: Chrome Battery Cover Trim
Table 2. Service Parts: Chrome Battery Cover Trim
Description (Quantity)
Chrome battery cover trim (Skull logo shown)
Original equipment parts, not included in kit:
Button-head screw
Battery cover
Battery cover tray, battery, and strap