VRSC Chrome Fork Sliders
J015802006-10-26
GENERAL
Kit Number
46526-02
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts and Tools Required
- Harley-Davidson TYPE E FORK OIL (HD-9984-80 16 oz.)
- A Harley-Davidson Service Manual for your model and year motorcycle
- Air impact wrench
- Torque wrench
- Fork Seal and Bushing Tool HD-34634 (large diameter)
- Fork Seal and Bushing Tool HD-36583 (small diameter)
- Pro-Level Oil Gauge HD-59000A
- Fork Tube Holder HD-41177
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
INSTALLATION
NOTE
Prior to installation of this kit, check the bore of the new chrome slider to be certain it is free of dirt and debris or damage to the new slider may occur.
| 1. | Support motorcycle so the front end is off the floor and the forks are fully extended. | |
| 2. | Remove the front fender, front brake caliper and front wheel according to the instructions found in the Chassis section of the appropriate Service Manual. | |
| WARNING Wear safety glasses or goggles when servicing fork assembly. Do not remove slider tube caps without relieving spring preload or caps and springs can fly out, which could result in death or serious injury. (00297a) | ||
| 3. | Remove and drain front fork according to instructions found in the Chassis section of the appropriate Service Manual. | |
| 4. | Check bores of chrome sliders from kit. Clean bores if they have become contaminated during shipping or storage. | |
| 5. | Disassemble front fork tubes according to instructions found in the Chassis section of the appropriate Service Manual and replace original fork sliders with chrome sliders from kit. | |
| 6. | Assemble the front fork tubes according to the instructions found in the chassis section of the appropriate Service Manual. | |
| 7. | Fill with TYPE E FORK OIL according to the instructions found in the applicable Service Manual. | |
| 8. | Install the front fork, front fender, wheel and caliper according to the instructions found in the Chassis section of the appropriate Service Manual. |
SERVICE PARTS
Figure 1. Service Parts: VRSC Chrome Fork Sliders
Table 1. Service Parts Table
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Chrome fork slider, left | Not Sold Separately |
2 | Chrome fork slider, right (not shown) | Not Sold Separately |
3 | Reflector, left | 59480-00 |
4 | Reflector, right (not shown) | 59481-00 |