HOG Footpeg Kit
J031952007-05-15
GENERAL
Kit Number
50364-04
Models
This footpeg kit fits all Harley-Davidson "male mount" style footpeg supports.
INSTALLATION
| 1. | Remove the locknuts and screws that hold the existing footpegs in place. Save all hardware for installation of the new footpegs. | |||||
| 2. | Remove the existing footpegs along with the spring washers. Save the spring washers for later installation. NOTE See Figure 3. When performing Step 3, make sure the spring washer is positioned inside of the footpeg support with the square edge towards the inside of the support as shown in Figure 2. | |||||
| 3. | Install the new footpegs in the same manner as the old footpegs were installed. Place a spring washer, along with the mount end of the footpeg, inside the slots of the footpeg supports. NOTE Secure each footpeg and spring washer with the screw and locknut removed earlier. Tighten the locknuts to 26 N·m (19 ft-lbs). NOTE Kit 50915-90T is shown, 50916-90T is similar. | |||||
 WARNINGFootrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a) | ||||||
| 4. | See Figure 1. For each footpeg, loosen the adjusting screw in the recessed hole until the footpeg rotates. Position the footpeg as desired, then tighten the adjusting screw to 29 N·m (21 ft-lbs) | 
Figure 1. Footpeg Adjusting Screw 
Figure 2. Footpeg Spring Washer Installation |
Service Parts
Figure 3. Service Parts: HOG Footpeg Kit
Table 1. Service Parts Table
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Screw, flat head, 5/16-18 x 1 in. (2) | 4682 |
2 | HOG® emblem (2) | 95744-04 |
3 | Mount, footpeg support (2) | 50351-03 |
4 | Left tread, HOG® footpeg | 50386-04 |
5 | Right tread, HOG® footpeg | 50388-04 |
6 | Left cover, HOG® footpeg | Not Sold Separately |
7 | Right cover, HOG® footpeg | Not Sold Separately |