ADJUSTABLE MALE-MOUNT FOOTPEGS
J011912007-05-15
GENERAL
Kit Number
50133-95, 50134-95, 50474-03, 50500-03
Models
These footpegs fit all Harley-Davidson "male mount" style footpeg supports as highway or passenger pegs only.
Kit Contents
See Table 1.
INSTALLATION
| 1. | Remove the locknuts and screws that hold the existing footpegs in place. Save all hardware for installation of the new footpegs. | |
| 2. | Remove the existing footpegs along with the spring washers. Save the spring washers for later installation. | |
| 3. | Install the new footpegs in the same manner as the old footpegs were installed. Place a spring washer, along with the mount end of the footpeg, inside the slots of the footpeg supports. Make sure the spring washer is positioned inside the footpeg support with the square edge towards the inside of support as shown at the bottom of Figure 1. | |
| 4. | Secure each footpeg and spring washer with the screw and locknut removed earlier. Tighten the locknuts to 26 N·m (19 ft-lbs). | |
| 5. | For each footpeg, loosen the adjusting screw in the recessed hole until the footpeg rotates. Position the footpeg as desired, then tighten the adjusting screw as follows: For Kits 50133-95, 50134-95 or 50500-03: Tighten to 29 N·m (21 ft-lbs). For Kit 50474-03: Tighten to 19–22 N·m (14–16 ft-lbs) |
WARNINGFootrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a)
| 1 | Bolt |
| 2 | Spring washer |
| 3 | Locknut |
| 4 | Adjusting screw (in recessed hole) |
Figure 1. Installing the Footpeg
| 1 | Spring washer |
Figure 2. Footpeg Spring Washer Installation
SERVICE PARTS
Table 1. Service Parts Table
Description (Quantity) | Part Number |
|---|---|
Kit 50133-95 (Airfoil-Large) | |
LH Footpeg | 50170-95 |
RH Footpeg | 50171-95 |
Adjusting Screws (2) | 2532 |
Kit 50134-95 (Airfoil-Small) | |
LH Footpeg | 50172-95 |
RH Footpeg | 50173-95 |
Adjusting Screws (2) | 2532 |
Kit 50474-03 (Airfoil-Extra Large) | |
LH Footpeg | 50476-03 |
RH Footpeg | 50475-03 |
Adjusting Screws (2) | 4115 |
Kit 50500-03 (Chrome and Rubber-Extra Large) | |
LH Footpeg | 50502-03 |
RH Footpeg | 50501-03 |
Adjusting Screws (2) | 4115 |