FLHR (Road King) Headlamp Visor Mounting Kit
Kit Number
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
Table 1. Kit Contents
Spring clips
Visor mounting pad
No Service Parts are available for this kit.
1. See Figure 1. Attach the headlamp visor mounting pad (3) to the underside of the headlamp visor (1) within approximately 1/16" (1.58mm) (2) of visor lip (4).
Your vehicle is already equipped with a headlamp door (trim ring).
1Headlamp visor
21/16" (1.58mm)
3Headlamp visor mounting pad
4Visor lip
Figure 1. Visor Mounting Pad Attachment to Visor
2. Remove headlamp door (trim ring) by removing screw at bottom of headlamp. Do not discard screw.
3. See Figure 2 and Figure 3. Place a spring clip (1) inside of trim ring (2), on each side of the stock clip, equally spaced as shown.
1Spring clip
2Trim ring
3Stock clips
Figure 2. Spring Clips and Trim Ring
1Spring clips
2Top of trim ring
3Visor lip location
Figure 3. Spring Clip/Visor Placement
4. Place visor lip between bottom of trim ring and spring clips. Center the visor to the stock clip at top of trim ring.
5. While holding visor in trim ring, push the trim ring back on headlamp.
6. Reattach trim ring to headlamp frame with screw removed in step 2.
7. If necessary, re-aim headlamp. See the Service Manual for detailed procedures.