ROCKER BOX CHROME HARDWARE KIT
J029202008-08-07
GENERAL
Kit Number
94291-04A
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
INSTALLATION
- Remove the main fuse following the instructions in the owner's manual or service manual.
- Replace existing zinc hardware with chrome plated hardware one at a time so the rocker cover and rocker cover gasket do not need to be replaced.
- Refer to the service manual for screw locations and torque values.
- Install the main fuse.
SERVICE PARTS
Figure 1. Service Parts: Rocker Box Chrome Hardware Kit
Table 1. Service Parts: Primary Cover Chrome Hardware Kit
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Screw, chrome socket head hex cap, 1/4-20 x 1.0 inch (8) | 94314-91TS* |
2 | Washer, chrome, 1/4-20 ID x 5/8 OD x 1/16 inch thick (8) | 6339 |
* Screws provided in this kit are shipped with threadlocker applied. If replacement screws are ordered, apply LOCTITE® 243 Threadlocker and Sealant - Blue (99642-97) to the threads before installation. | ||