Front Sprocket Cover Inserts Kit
J023002006-05-06
GENERAL
Kit Number
44493-02
Models
This kit fits 2002-2006 VRSCA, VRSCB and VRSCD models.
NOTE
Do not install this kit if ambient temperature is less than 60° F. Inserts may be installed directly over the stock inserts.
Kit Contents
Table 1. Kit Contents
Description (Quantity) | Part Number |
|---|---|
Front sprocket cover insert (2) | Not Sold Separately |
INSTALLATION
| 1. | Clean the surface of the sprocket-cover insert area with a 50/50 mixture of isopropyl alcohol and water. Allow the cleaned surface to dry. | |
| 2. | Peel the backing off of a sprocket-cover insert. Use a tweezer to hold and precisely position the insert. | |
| 3. | See Figure 1. Carefully place the insert on the sprocket cover within the recessed area (1) on the cover. Apply even pressure to the insert for at least 1 minute. | |
| 4. | Repeat Steps 1 - 3 for the remaining insert. NOTE Allow the adhesive to cure for 24 hours before operating the motorcycle. |  Figure 1. Sprocket Cover Insert Location |