RADIO FACEPLATE TRIM
J038282006-10-12
GENERAL
Kit Number
77142-06
77143-07
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
Table 1. Kit Contents
Description (Quantity) | Part Number |
|---|---|
Radio faceplate trim | Not Sold Separately |
INSTALLATION
NOTE
Mounting surface of radio faceplate trim must be above 60°F (16°C), or the trim may not stay attached.
| 1. | Using a 50:50 isopropyl alcohol/water solution, thoroughly clean the surface where the radio faceplate trim will be installed. | |
NOTICE Do not clean with denatured alcohol, mineral spirits, or other solvent products, or component damage may occur. (00411c) | ||
| 2. | Allow the surface to dry completely before continuing to install kit. | |
| 3. | Test the fit of the radio faceplate trim prior to removing adhesive backing. | |
| 4. | Remove the adhesive backing from the back of the radio faceplate trim. | |
| 5. | Open the auxiliary jack cap and feed it through the radio faceplate trim. | |
| 6. | See Figure 1. Position the radio faceplate trim and press firmly into place. | |
| 7. | Let the adhesive cure for at least 24 hours at no less than 60°F (16°C). |
Figure 1. Radio Faceplate Trim