SCREAMIN' EAGLE® PRO EFI RACE TUNER CABLE KIT
J041462008-01-21
GENERAL
Kit Number
32108-06
Models
This kit fits with all Screamin' Eagle Pro EFI Race Tuners.
Additional Parts Required
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Screamin' Eagle Pro EFI Race Tuner, Kit Number 32107-01F or Kit Number 32127-03A.
Kit Contents
This kit contains the cables required to connect the Pro Race Tuner Interface Module to the motorcycle and user's computer. See Table 1
Table 1. Kit Contents
Description (Quantity) | Part Number |
|---|---|
Motorcycle Data Connector Cable | 32116-01 |
Computer Serial Cable | 32115-01 |
CONNECTING COMPUTER, INTERFACE AND CABLES TO PROGRAM ECM
| 1 | Data cable |
| 2 | Serial Cable |
| 3 | 4-Pin connector to motorcycle |
| 4 | 9-Pin connector to computer serial port |
| 5 | Interface module |
Figure 1. Screamin' Eagle Pro EFI Race Tuner Cables
NOTE
Refer to the Service Manual for location of the Data Connector.
- Refer to the Race Tuner manual for complete instructions of installation and use.
- Turn motorcycle ignition OFF
- See Figure 1. Plug 4-pin Data Cable into 4-Pin Data connector on motorcycle and verify snapped in place
- Plug 9-Pin female end of Data cable into Interface Module and tighten thumb screws.
- Plug 9-Pin female end of Serial cable into computer Serial port and tighten thumb screws.
NOTE
The EFI Tuner Interface Module is a "single unit: design that permanently links to the ECM the first time communication is established. The Interface Module can then be used an infinite number of times with that ECM, but the Interface Module will not communicate with any other ECM's.
Owner must store Interface Module in a secure place for future tuning or data recording. If the Interface Module is lost or broken a new Screamin' Eagle EFI Tuner kit must be purchased to obtain a new Interface Module that can communicate with the ECM.