Obtain the Road Tech 75 Radar and Laser Detector (sold separately). See Figure 1. Position the detector (E) to the bracket and mount assembly (2), with the controls on the left top surface. Slide the detector forward into the slot on the top of the mount until the tab engages with two sharp "clicks".

To remove, firmly press upward on the release tab located on the underside of the detector, and slide the detector backward to disengage it from the mount.

Thoroughly clean the inside surfaces of both the windshield and all three suction cups (3), and allow to air dry before installing the suction mount.

Place the bracket mount and detector assembly in the desired location on the windshield. Hold the suction cups against the glass and push the button ends (B) toward the windshield so that the suction mount is gripped firmly against the windshield. Apply gentle pressure to the suction mount to make certain the grip is secure.

If necessary, slightly loosen the screw (4) and hex nut with washer (5) on each side of the bracket assembly (2). Adjust the angle of the lower bracket so that the detector is parallel to the surface of the road. Re-tighten the screws and hex nuts. Double-check the suction mount's firm hold on the windshield.

To remove the suction mount from the windshield, pull the tabs (C) on the suction cups away from the windshield to help release the grip.

Plug the adapter into an available 12/24 Volt DC power receptacle (cigarette lighter or power point) in the vehicle. Use care when routing the cable to ensure that it does not interfere with vehicle operation in any way.