0/0
Molded Tour-Pak Liner Kits
J037522006-07-25
GENERAL
Kit Number
53285-06, 53301-06, 53302-07
Models
Kit 53285-06 fits all models equipped with a Chopped Tour-Pak except when equipped with Tour-Pak bottom tub-mounted accessories.
Kit 53301-06 fits all models equipped with a King Tour-Pakwith wrap-around tail lights except when equipped with Tour-Pak bottom tub-mounted accessories.
Kit 53302-07 fits all models equipped with a King Tour-Pakwithout wrap-around tail lights or Tour-Pak bottom tub-mounted accessories.
Kit Contents
Table 1. Kit Contents
Description (Quantity)
Part Number
Velcro Kit (2)
53314-06
Tour-Pak Liner
Not Sold Separately
INSTALLATION
NOTE
Skip steps 2 and 7 for King Tour-Pak Liner kits 53301-06 and 53302-07, and Skip steps 1 and 8 for Chopped Tour-Pak liner kit 53285-06.
  1. King Tour-Pak only: Remove stock document pouch by removing the acorn nuts, mounting screws, and washers from inside pouch. Save for reinstallation later (for models WITH wrap-around tail lights, remove acorn nuts and washers only, leave the lock-nuts attached to the Tour-Pak).
  2. Chopped Tour-Pak only: Remove the cover tether from Tour-Pak bottom. Save screw and washer for re-installation.
  3. Wash the inside of the Tour-Pak with warm, soapy water. Rinse and dry thoroughly.
  4. Use the alcohol prep pad in the kit to thoroughly clean the interior surface of the Tour-Pak sides where hook fastener strips will be attached. Make sure any residue is removed, then allow Tour-Pak to dry completely. Make sure the surface is free of condensed moisture.
  5. See Figure 1 to locate hook fastener strips. Peel the backing paper from the adhesive side of the hook fastener strips and press the strips against the wall of the Tour-Pak.
  6. Place the liner into the Tour-Pak and press the liner surfaces against the hooks. Rub each strip firmly onto the Tour-Pak wall from the inside of the liner.
  7. Chopped Tour-Pak only: Install tether to Chopped Tour-Pak bottom with original screw and washer retained in Step 2.
  8. King Tour-Pak only: Install document pouch using saved hardware from step 1 as follows: For models WITHOUT wrap-around tail lightsFor models WITH wrap-around tail lights
    1. Flip up backrest flap.
    2. Insert the screw into the Tour-Pak mounting hole behind the rider backrest flap.
    3. Open document pouch to access the plastic mounting insert.
    4. Place washer over screw threads and hand-tighten the acorn nut.
    5. Using a T-25 Torx® key wrench and 3/8-inch wrench on the acorn nut, tighten to 21-24 in-lbs (2.37-2.71 Nm).
    1. Open document pouch to access the plastic mounting insert.
    2. Place washer over screw threads, and hand tighten the acorn nut.
    3. Using a T-25 Torx® key wrench and 3/8-inch wrench on the acorn nut, tighten to 21-24 in-lbs (2.37-2.71 Nm).
1Hook fastener location, all sides
2Tether screw location (Chopped Tour-Pak only)
3Pouch mount holes (Tour-Pak w/wrap-around lights)
4Pouch mount holes (Tour-Pak w/o wrap-around lights)
Figure 1. Tour-Pak Liner (Chopped version shown)