FRONT MASTER CYLINDER REBUILD KIT FOR XR1200
J047112008-03-10
GENERAL
Kit Number
42736-08
Models
This kit fits all 2008 and later XR1200 models.
Additional Parts Required
Proper installation of this kit requires new D.O.T. 4 Hydraulic Brake Fluid (99953-99A) and two brake line gaskets (41743-04). It may be necessary to replace other parts as determined by inspection.
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
Table 1. Kit Contents
Qty | Description | Part Number |
|---|---|---|
1 | Retaining ring, piston | 11142 |
1 | Retaining ring, pivot pin | 11379 |
1 | Dust cover | Not Sold Separately |
1 | Spring | Not Sold Separately |
1 | Secondary cup | Not Sold Separately |
1 | Primary cup | Not Sold Separately |
1 | Piston | Not Sold Separately |
1 | Brake grease, G40M | 42820-04 |
1 | Brake grease, CCI #20 | 42830-05 |
INSTALLATION
The parts included in this kit are direct replacements for the stock parts. Refer to the appropriate Service Manual and follow the instructions to remove, disassemble, inspect, assemble and install the front brake master cylinder. Use the parts included in this kit to replace the existing parts of the rear master cylinder.