Kit Number
51376-09, 50500435, 50500717
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of (English only).
Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a)
Kit Contents
Table 1. Kit Contents
Description (Quantity)
Part Number
Assembly, footpeg (left)
Not Sold Separately
Assembly, footpeg (right)
Not Sold Separately
Clevis pin (2) (50500717)
Retaining ring (2) (50500717)
1. See Figure 1. Remove screw (1) and locknut (2) from each footpeg. Save hardware.
2. Remove each footpeg with spring washer. Save spring washers.
Make sure the spring washer is positioned in the slot between the footpeg support and footpeg with the straight edge toward the inside of the support as shown.
Install new footpegs. Place spring washer (3) and footpeg in the slot of the footpeg support.
4. Secure footpeg with screw and locknut that was previously removed or clevis pin (1) and retaining ring (2) provided in kit (Part No. 50500717). Tighten locknuts:
Torque: 26 N·m (19 ft-lbs) Locknuts
5. See Figure 1. For each footpeg, loosen adjusting screw (4). Position footpeg as desired and tighten screw.
a. 50500135 and 5050717:
Torque: 20–24 N·m (15–18 ft-lbs) Adjusting screw
b. 51379-09:
Torque: 29 N·m (21 ft-lbs) Adjusting screw
1Screw (or clevis pin), top
2Locknut (or retaining ring), bottom
3Spring washer
4Adjusting screw
Figure 1. Installing the Footpeg