GLOSS BLACK TRIPLE TREE COVER KIT
J048842009-06-03
GENERAL
Kit Number
48608-09
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
INSTALLATION
| 1. | Refer to the service manual to remove the front panel, side panels and trim strips. Save all hardware to install the new panels from the kit and trim strips. | |
| 2. | See Figure 1 and Table 1. Install new panels from the kit and trim strips (D). | |
| 3. | Tighten screw (A), three places, to 2.26–3.39 N·m (20–30 in-lbs) Tighten screw (B), two places, to 16.3–23 N·m (12–17 ft-lbs) Tighten screw (C), four places, to 10.8–16.3 N·m (8–12 ft-lbs). If installing on a motorcycle with a light bar or windshield, refer to the appropriate service manual or instruction sheet for torque values. |
SERVICE PARTS
Figure 1. Service Parts: Gloss Black Triple Tree Cover Kit
Table 1. Service Parts Table
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Front panel, gloss black | 67987-10BHP |
2 | Rear back panel, left | 67993-10BHP |
3 | Rear back panel, right | 67988-10BHP |
Items mentioned in text, but not included in kit: | ||
A | Screw (3) | 941 |
B | Screw (2) | 3953W |
C | Screw (4) | 3538 |
D | Trim strip, black (2) | 68055-10BHP |